This kits is a result of our effort to improve existing and popular Z-brace kits based on 3D printed parts. Our kit is fully metal kit, no printed parts. It looks minimal compared to the 3D printed Z-brace designs, but it will make your frame completely stable, just like other similar kits.
In our kit we use ball joints to eliminate any tension created by misalignment between upper and lower bracket. Off shelf M5 ball rod ends are making our Z-brace design simple and clean looking.
Convenient feature of our kit is ability to allow fine adjustment of the each Z-rod length. Z-Brace rod design is based on turnbuckle principle – each rod will extend and contract by turning tube clockwise or counterclockwise. When you are done with adjustment – just tighten counter nuts on each rod end to get rid of any small play and you will make your adjustment permanent. After you tighten counter nuts your frame will become completely solid and stable.
2 x Aluminum tubes pre-assembled with 2 x M5 steel ball rod ends (left hand and right hand threaded) and 2 x M5 counter nuts (left hand and right hand threaded).
2 x Lower mounting brackets.
2 x Upper mounting brackets.
10 x M3x8 socket head screws.
5 x M5x12 socket head screws.
Very stiff all metal construction