Pixnor 3D Printer Controller RAMPS 1.4 for REPRAP MENDEL PRUSA Arduino



buy now

$10.98



Description

This is a professional 3D printer controller, fully assembled tested, no soldering required, designed to fit the entire electronics needed for a RepRap in one small package for low cost. The modular design includes plug in stepper drive and extruder control electronics on an Arduino MEGA shield for easy service, part replacement, upgrade-ability and expaion. A number of Arduino expaion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack.

Features

– Size: 11.5cm x 6cm / approx. 4.5in x 2.4in.
– Fully assembled tested, no soldering required.
– It is designed to fit the entire electronics needed for a RepRap in one small package for low cost.
– The modular design includes plug in stepper drive and extruder control electronics on an Arduino MEGA shield for easy service, part replacement, upgrade-ability and expaion.
– A number of Arduino expaion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack.
——————————————————–
Package Including
1 * 3D Printer Controller RAMPS 1.4 for REPRAP MENDEL PRUSA ArduinoSize: 11.5cm x 6cm approx. 4.5in x 2.4in.