C.W.USJ products are favored by consumers because of “high quality and low price”. They are exported to the United States, Canada, Mexico and some surrounding European
3 Model B+ Power over Ethernet HAT 802.3af PoE Network Power-Sourcing Equipment required support only RPI 3B+
The Raspberry Pi Power over Ethernet HAT is a small accessory for the Raspberry Pi computer. It can only be used with the Raspberry Pi 3 Model B+ (launched March 2018).
The PoE HAT allows you to power your Raspberry Pi using Power over Ethernet-enabled networks; for this product to be used, the network it is connected to needs to have power-sourcing equipment installed.
Fully isolated switched-mode power supply
37-57V DC, Class 2 device
5V/2.5A DC output
25mm x 25mm brushless fan for processor cooling
How to Use:
Raspberry Pi PoE HAT (this product)
A Raspberry Pi 3 Model B+ (not included)
An Ethernet cable (not included)
Power-sourcing equipment for a 802.3af Power over Ethernet network (not included)
Connecting your PoE HAT to the Raspberry Pi
Before installing the PoE HAT, you must attach the supplied spacers in the four corners of the board
Then connect the Raspberry Pi PoE HAT to the two 0.1″ headers (40 + 4) that are fitted on the Raspberry Pi
Once the PoE HAT board is connected, you can power the Raspberry Pi through its RJ45 network connector
Disconnecting your PoE HAT
Pull evenly so that it detaches from all the pins at the same rate; do not pull one end of the connector off before the other
No modification to the main Raspberry Pi board is needed for this product to work. Please ensure that your Raspberry Pi’s software is up to date for all functionality to be available.
The PoE HAT is fitted with a small fan that is controlled by the Raspberry Pi via I2♥Simple design, fast installation. Easy to use and apply.
Cooling fan: 25mm × 25mm brushless fan delivering 2.2CFM for processor cooling.
Features: Fully isolated switched-mode power supply, Fan control.
Input voltage: 37-57V DC, Class 2 device
Output power: 5V DC/2.5A